Version: 7.9
Stable130 changelog entries across 47 component(s)
2023-May-02 (2 years ago)
| Component | Change |
|---|---|
| bgp | improved BGP VPN selection; |
| bridge | added warning log when "ageing-time" exceeds supported hardware limit for 98DX224S, 98DX226S, and 98DX3236 switch chips; |
| bridge | fixed FastPath when setting "use-ip-firewall-for-vlan" or "use-ip-firewall-for-pppoe" without enabled "use-ip-firewall"; |
| certificate | fixed bogus log messages; |
| chr | fixed public SSH key pulling when running on AWS; |
| console | added "/task" submenu (CLI only); |
| console | added option to create new files using "/file add" command (CLI only); |
| console | improved stability when doing "/console inspect" in certain menus; |
| console | improved stability when editing long strings; |
| console | improved system stability; |
| console | removed bogus "reset" command from "/system resource usb" menu; |
| console | rename flag "seen reply" to "seen-reply" under "/ipv6 firewall connection" menu; |
| console | replaced "fingerprint" with "skid" in "/certificate print"; |
| console | show Ethernet advertise, speed and duplex settings depending on configured auto-negotiation; |
| container | fixed invoking "container shell" more than once; |
| container | improved "container pull" to support OCI manifest format; |
| defconf | added CAPs mode script for wifiwave2 devices; |
| detnet | fixed interface state detection after reboot; |
| dhcp | changed the default lease time for newly created DHCP servers to 30 minutes; |
| dhcpv4-server | release lease if "check-status" reveals no conflict; |
| disk | improved system stability when removing USB while formatting; |
| ethernet | fixed half-duplex forced mode at 10Mbps and 100Mbps on ether1 for RB5009, Chateau 5G ax and hAP ax3 devices; |
| filesystem | fixed partition "copy-to" function; |
| firewall | added "connection-nat-state" to IPv6 mangle and filter rules; |
| general | mpls- fixed LDP "preferred-afi" parameter; |
| health | added limited manual control over fans for CRS3xx, CRS5xx, CCR2xxx devices; |
| health | fixed bogus value reporting for CRS510 device; |
| ike2 | fixed minor logging typo; |
| ipsec | added error log message when peer ID does not match certificate; |
| ipsec | fixed packet processing by hardware encryption engine on RB850Gx2 device; |
| ipsec | refactor X.509 implementation; |
| ipv6 | added "valid" and "lifetime" parameters for SLAAC IPv6 addresses; |
| ipv6 | send out RA packet with "preferred-lifetime" set to "0" when IPv6 address is deactivated; |
| l3hw | improved route offloading for 98DX224S, 98DX226S, and 98DX3236 switch chips; |
| leds | disable LEDs after "/system shutdown"; |
| lte | capped maximum lifetime of SLAAC address to 1 hour; |
| lte | fixed CA band clearing on RAT mode change; |
| lte | fixed duplicate IPv6 route for lte interface when "ipv6-interface" setting is used; |
| lte | fixed LTE interface not showing up when resetting RouterOS configuration; |
| lte | fixed passthrough mode when used together with another APN for Chateau 5G; |
| lte | fixed R11-LTE-US in LTE passthrough mode; |
| lte | fixed R11e-LTE-US reporting of RSSI in LTE mode; |
| lte | fixed re-attach in some cases where module would stay in not-running state after network detach; |
| lte | fixed second modem halt on dual R11e-LTE6 setup; |
| lte | improved system stability when changing LTE interface configuration during network scan with MBIM modems (introduced in v7.8); |
| netinstall-cli | improved device reinstall on failed attempt; |
| netwatch | added "startup-delay" setting (CLI only); |
| netwatch | improved ICMP status evaluation when no reply was present; |
| netwatch | limit "start-delay" range; |
| ospf | fixed processing of fragmented LSAs; |
| ovpn | added support for OVPN server configuration export and client configuration import from .ovpn file; |
| ovpn | improved system stability for Tile devices; |
| quickset | fixed displaying of "SINR" when value is 0; |
| rose-storage | added option to nvme-discover with hostname (CLI only); |
| rose-storage | fixed crash on nvme-tcp disable; |
| rose-storage | fixed rsync transfer permissions; |
| rose-storage | various stability fixes; |
| route | fixed "dynamic-id" for VRF tables; |
| route | improved system stability when making routing decision; |
| route | show SLAAC routes under the "/routing route" menu; |
| route-filter | improved stability when matching blackhole routes; |
| routerboot | added "preboot-etherboot" and "preboot-etherboot-server" settings ("/system routerboard upgrade" required) (CLI only); |
| sfp | added log warning about failed auto-initialization on RB4011, RB5009, CCR2004-1G-12S+2XS, CCR2004-16G-2S+, CCR2116-12G-4S+, CCR2216-1G-12XS-2XQ devices; |
| sfp | allow modules that hold "TX_FAULT" high signal all the time on RB4011, RB5009, CCR2004-1G-12S+2XS, CCR2004-16G-2S+, CCR2116-12G-4S+, CCR2216-1G-12XS-2XQ devices; |
| sfp | allow modules with bad or no EEPROM in forced mode on RB4011, RB5009, CCR2004-1G-12S+2XS, CCR2004-16G-2S+, CCR2116-12G-4S+, CCR2216-1G-12XS-2XQ devices; |
| sfp | fixed "rate-select" functionality on CCR2004-16G-2S+ and CCR2004-1G-12S+2XS devices (introduced in v7.8); |
| sfp | fixed combo-ether link monitor for CRS328-4C-20S-4S+ switch; |
| sfp | improved module initialization and display more detailed initialization status on RB4011, RB5009, CCR2004-1G-12S+2XS, CCR2004-16G-2S+, CCR2116-12G-4S+, CCR2216-1G-12XS-2XQ devices; |
| sfp | improved SFP28 interface stability with some optical modules for CRS518 switch; |
| sfp | improved system stability with some SFP GPON modules on RB4011, RB5009, CCR2004-1G-12S+2XS, CCR2004-16G-2S+, CCR2116-12G-4S+, CCR2216-1G-12XS-2XQ devices; |
| snmp | fixed SNMPv3 "Reportable" flag behavior; |
| snmp | improved outputting of routes; |
| socks | added VRF support; |
| ssh | added Ed25519 host key support; |
| ssh | added support for Ed25519 key export and import in PKCS8 format; |
| ssh | do not allow SHA1 usage with strong crypto enabled; |
| ssh | improved service responsiveness when changing SSH service settings; |
| ssh | improved SSH key import process; |
| storage | mount RAM drive for devices with 32MB flash; |
| supout | added DHCP server network section; |
| switch | fixed ACL rules matching IPv6 packets when using only IPv4 matchers; |
| switch | improved system stability during rapid MAC flapping for 98DXxxxx switches; |
| switch | improved system stability for 98DX8208, 98DX8216, 98DX8212, 98DX8332, 98DX3257, 98DX4310, 98DX8525, 98DX3255, 98PX1012 switches; |
| timezone | updated timezone information from "tzdata2023c" release; |
| vrrp | added "self" value for "group-master" setting; |
| vxlan | added forwarding table; |
| vxlan | fixed packet drops when host moves between remote VTEPs; |
| webfig | added inline comments; |
| webfig | fixed "Destination" value under "MPLS/Forwarding-Table" menu; |
| webfig | fixed issue where "Certificate" value disappears under "IP/Services" menu; |
| webfig | fixed issue where entries might be missing under "IP/DHCP-Server" menu; |
| webfig | various stability fixes; |
| wifiwave2 | added "radio/reg-info" command to show regulatory requirements (currently implemented for 802.11ac interfaces) (CLI only); |
| wifiwave2 | added ability to configure antenna gain; |
| wifiwave2 | added ability to configure beacon interval and DTIM period; |
| wifiwave2 | added information on additional interface capabilities to radio parameters; |
| wifiwave2 | automatically add a VLAN-tagged interface to the appropriate bridge VLAN; |
| wifiwave2 | exit sniffer command and return error when trying to sniff on an unsupported channel; |
| wifiwave2 | fixed 802.11r roaming for clients that performed initial authentication with an AP which has been restarted since; |
| wifiwave2 | fixed issue of some supported channels not being listed in the radio parameters; |
| wifiwave2 | fixed issue which lead to VLAN-tagged wireless clients receiving tagged traffic from other VLANs; |
| wifiwave2 | fixed key handshake timeout for re-associating client devices on 802.11ac interfaces; |
| wifiwave2 | fixed VLAN tagging for unencrypted (open) APs; |
| wifiwave2 | improved general interface stability; |
| wifiwave2 | improved regulatory compliance for hAP ax^2, hAP ax^3 and Chateau ax; |
| wifiwave2 | improved WPS connection speed; |
| wifiwave2 | increased maximum value for "channel.frequency" to 7300; |
| wifiwave2 | show information on captured packets and added ability to save them locally in a pcap file; |
| winbox | added "MTU" and "Hoplimit" properties under "IPv6/Routes" menu; |
| winbox | added "Preferred AFI" property under "MPLS/LDP-Instance" menu; |
| winbox | added "S" flag under "IPv6/Firewall/Connections" menu; |
| winbox | added "Tx Power" property under "Wifiwave2/Status" menu; |
| winbox | added "Tx Queue Drops" property under interface settings "Traffic" tab; |
| winbox | added "Username" and "Password" properties under "Container/Config" menu; |
| winbox | added "Valid" and "Preferred" properties under "IPv6/Address" menu; |
| winbox | added missing properties for "Remote ID Type" under "IP/IPsec/Identities" menu; |
| winbox | changed route flag name from "invalid" to "inactive"; |
| winbox | fixed "TLS" property under "Tools/Email" menu; |
| winbox | fixed "Type" property under "System/Disk" menu when "rose-storage" package is installed; |
| winbox | fixed changing slot name under "System/Disk" menu; |
| winbox | fixed default value for "Allow managed" property under "Zerotier" menu; |
| winbox | fixed duplicate "My ID" column under "IP/IPsec/Identities" menu; |
| winbox | fixed minor typo in "WifiWave2/Radios" menu; |
| winbox | fixed missing "Sector Writes" for certain devices under "System/Resources" menu (introduced in v7.8); |
| winbox | improved Ethernet advertise, speed and duplex settings; |
| winbox | only show permitted countries for wifiwave2 interfaces; |
| winbox | show missing "Designated Bridge" and "Designated Port Number" monitoring data under "Bridge/Port menu; |
| www | allow unsecure HTTP access to REST API; |
| x86 | fixed changing software-id (introduced in v7.7); |
| zerotier | upgraded to version 1.10.3; |