Version: 7.19.6
Stable24 changelog entries across 14 component(s)
2025-Sep-12 (4 months ago)
| Component | Change |
|---|---|
| bridge | improved system stability with IGMP snooping; |
| ethernet | improved performance for hEX Refresh and hEX S (2025); |
| ike2 | improved system stability; |
| leds | fixed signal strength LEDs for Cube 60G ac; |
| log | added VRF support for remote logging; |
| log | establish a new connection to the remote log server when action settings are edited (e.g. after changing the src-address property); |
| log | fixed memory leak when a connection to remote TCP log server failed; |
| log | fixed unsent message retransmit to correct endpoints (introduced in v7.18); |
| log | randomize source port when using remote logging with src-address specified; |
| lte | fixed wrong subnet mask set to Chateau 5G R17 ax LTE interface; |
| mac-server | fixed interface-list change behavior; |
| poe-out | added "poe-in" detection for 802.3at poe-out capable ports; |
| poe-out | firmware update for 802.3at capable boards (the update will cause brief power interruption to poe-out interfaces); |
| poe-out | fixed "low-voltage" LLDP deny for RB5009 and RB960 in specific voltage/power-source combinations; |
| poe-out | fixed missing error status report in rare cases for 802.3at; |
| routerboot | fixed load of other kernels (e.g. OpenWrt) on NAND-less boards with MT762x, IPQ40xx, QCA955x and QCA953x CPUs ("/system routerboard upgrade" required); |
| sfp | fixed the I2C clock frequency for the hEX S (2025) to prevent EEPROM read issues with GPON modules; |
| switch | fixed switch name for CRS418; |
| switch | improved system stability after switch reset while bonding interfaces are active (introduced in v7.18); |
| traffic-flow | added support for IPv6 packet sampling; |
| traffic-flow | fixed flow reports when using IPv6 and packet sampling (introduced in v7.18); |
| w60g | fixed disconnect issue (introduced in v7.19.4); |
| winbox | allow selecting bonding interface under "Switch/Rule" menu; |
| winbox | use "auto" as default value for VXLAN "Don't Fragment" property; |